Create C300 Controller And Cee Function Blocks; To Configure A C300 Controller Block - Honeywell Experion C300 User Manual

Create C300 Controller and CEE function blocks

To configure a C300 Controller block

Create C300 Controller and CEE function blocks
You create function blocks that represent a C300 Controller and its associated Control
Execution Environment (CEE). Once created, the function blocks appear in the Project
tab view of Control Builder. The CEEC300 block supports execution of a set of function
blocks for solving control applications which run in the C300 as a software layer built on
top of the control software infrastructure.
Two additional EE blocks are also created when a C300 Controller block is created.
These blocks, IOLINK1 and IOLINK 2, provide the controller interface for associated
Series C and Process Manager I/O Module blocks.
TIP
You can configure a C300 Controller block in the Control Builder Project tab
without the controller hardware being installed.
Prerequisites
You have started Configuration Studio and launched the Control Builder application.
•
You have logged on with sufficient privileges to create control strategies using
•
Control Builder.
You have configured the applicable IP addresses when you set up your FTE
•
network.
You have configured applicable Base IP addresse and IP addresses for network time
•
protocol (NTP) servers through the System Preferences dialog in Control Builder.
See the Setting system preferences in the Control Building User's Guide for more
information about setting IP addresses.
Considerations
All illustrations used in the procedure are for example purposes only.
To configure a C300 Controller block
Step
1
Click File > New > Controllers > C300
Controller (2 I/O Links).
36
Action
Experion C300 Controller User's Guide
Honeywell
Result
Calls up the C300 Block configuration
form with a default Tag Name field
highlighted.
R301.1
11/06