Dell C9000 Series Reference Manual page 1771

interface
direction {rx | tx |
both}
Defaults none
Command Modes MONITOR SESSION (conf-mon- sess-session-ID)
Command History
This guide is platform-specific. For command information about other platforms, see to
the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.5(0.1)
9.4.0.0
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
8.5.1.0
8.1.1.0
7.7.1.0
7.5.1.0
7.4.1.0
• For a remote VLAN interface, enter the keyword Remote-
VLAN and a vlan-id number. Range is from 1 to 4094
Enter the one of the following keywords and slot/port
information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a VLAN interface, enter the keyword VLAN and a vlan-id
number. Range is from 1 to 4094.
• For a port channel interface, enter the keyword port-
channel amd a the port-channel ID.
Enter the keyword direction then one of the packet
directional indicators.
• rx: to monitor receiving packets only.
• tx: to monitor transmitting packets only.
• both: to monitor both transmitting and receiving packets.
Description
Introduced on the C9010.
Introduced on the Z9500.
Added support for Source and destination.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Added support for 4-port 40G line cards on ExaScale.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Port Monitoring 1771