Dell C9000 Series Reference Manual page 1759

Parameters
pe pe-id
stack-unit unit
number
interface interface
Defaults None
Command Modes
•
•
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
Usage Information The following describes the output fields of the show power inline command:
Field
Interface
Inline Power
Allocated
Inline Power
Consumed
Class
Enter the keyword pe and the port extender ID. Range is from 0
to 255.
Enter the keyword stack-unit and the stack unit number
Range is from 0 to 7.
Enter the interface keyword, and specify one of the following
interface types:
• For a PE Gigabit Ethernet interface, enter the keyword
peGigE. You must specify a pe-id/Unit/Port for the
interface.
.
EXEC
EXEC Privilege
Description
Introduced on the C9010.
Description
Displays the line card or the port extender interface slot and port
number.
Displays the amount of power allocated to the port.
Displays the amount of power consumed by the connected
device.
Displays the power classification of the connected device. If the
device is powered up properly, it displays Class 0, 1, 2, 3, or 4.
Displays the following under different conditions:
• NO_DEVICE if no device is present.
• LEGACY if a legacy device is connected.
• PD_S/C if a short-circuit condition is detected.
• PD_OVRLD if overload condition is detected.
Port Extenders (PE) 1759