The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.7(0.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
8.2.1.0
8.1.1.0
7.7.1.0
7.6.1.0
6.2.1.1
Usage Information This command changes the sampling rate for an interface. By default, the sampling rate
of an interface is set to the same value as the current global default sampling rate if
port is operationally down, otherwise sampling rate changes based on port line speed.
If the value entered is not a correct power of 2, the command generates an error
message with the previous and next power-of-2 value. Select one of these two number
and re-enter the command.
Related
sflow sample-rate (Global)
Commands
show sflow
Display the current sFlow configuration.
Syntax
show sflow [interface]
Parameters
interface
Description
Introduced on the C9010.
Introduced on the S6000-ON.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on S-Series Stacking.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— changes the sampling rate globally.
(OPTIONAL) Enter the following keywords and slot/port or
number information:
•
For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
•
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
•
For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
•
For a Loopback interface, enter the keyword loopback
then a number from 0 to 16383.
sFlow
2037