Logging History Size - Dell C9000 Series Reference Manual

Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.6.1.0
7.5.1.0
Usage Information When you configure the snmp-server trap-source command, the system
messages logged to the history table are also sent to the SNMP network management
station.
Related
show logging
Commands

logging history size

Specify the number of messages stored in the logging history table.
C9000 Series
Syntax
logging history size size
To return to the default values, use the no logging history size command.
Parameters
size
Defaults 1 message
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
— displays information logged to the history buffer.
Indicate a value as the number of messages to be stored. The
range is from 0 to 500. The default is 1 message.
Description
Introduced on the Z9500.
Simple Network Management Protocol (SNMP) and Syslog 2080