Dell C9000 Series Reference Manual page 1312

output-range
interface
vlan vlan-id
Defaults Not configured.
Command Modes
CONFIGURATION
CONFIGURATION TERMINAL BATCH
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.10(0.0)
9.9(0.0)
9.2(1.0)
9.1(0.0)
8.3.19.0
8.3.11.1
8.5.1.0
8.3.7.0
7.6.1.0
7.5.1.0
6.2.1.1
Example (Unicast)
mac-address-table static 00:01:00:00:00:01 {output Te 0/2 vlan 2}
Example
mac-address-table static 01:00:5E:01:00:01 {multicast vlan
(Multicast)
2 output—range Te 0/2,Te 0/3}
Related show mac-address-table
Commands
For a multicast MAC address, enter the keyword output-range
then one of the following interfaces to indicate a range of ports
for which traffic is forwarded:
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
Enter the keyword vlan then a VLAN ID number from 1 to 4094.
Description
Introduced the Configuration Terminal Batch mode on C9010.
Introduced on the C9010.
Introduced on the Z9500.
Added support for output range parameter for S4810 and
Z9000.
Introduced on the S4820T.
Introduced on the Z9000.
Added support for 4-port 40G line cards on ExaScale.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— displays the MAC address table.
Layer 2 1312