Call-Progress Tone Parameters; List Of Call-Progress Tone Parameters; Tone Parameter Syntax - Cisco ATA 188 Administrator's Manual

Chapter 5 Parameters and Defaults

Call-Progress Tone Parameters

This section covers all the call-progress tones that the Cisco ATA supports, and contains the following
topics:
•
•
•
•
•

List of Call-Progress Tone Parameters

The following list contains the names of the call-progress tone parameters:
•
•
•
•
•
•

Tone Parameter Syntax

Each tone is specified by nine integers, as follows:
ntone, freq0, freq1, level0, level1, steady, on-time, off-time, total-tone- time
•
•
Note
•
•
•
•
•
•
Ol-3141-01
List of Call-Progress Tone Parameters, page 5-21
Tone Parameter Syntax, page 5-21
How to Calculate Scaling Factors, page 5-22
Recommended Values, page 5-22
Specific Call-Progress Tone Parameter Information, page 5-23
DialTone
BusyTone
ReorderTone
RingBackTone
CallWaitTone
ConfirmTone
ntone is the number of frequency components (0, 1 or 2).
freq[0] (Hz) is the transformed frequency of the first frequency component (-32768 to 32767).
Only positive values can be configured to the Cisco ATA 186. For negative values, use the 16-bit
2's-complement value. For example, enter -1 as 65535 or 0xffff.
freq[1] is the transformed frequency of the second frequency component (-32768 to 32767).
level[0] is the transformed amplitude of the first frequency component (-32768 to 32767).
level[1] is the transformed amplitude of the second frequency component (-32768 to 32767).
steady controls whether the tone is constant or intermittent. A value of 1 indicates a steady tone and
causes the Cisco ATA to ignore the on-time and off-time parameters. A value of 0 indicates an on/off
tone pattern and causes the Cisco ATA to use the on-time and off-time parameters.
on-time controls the length of time the tone is heard in milliseconds (ms) expressed as an integer
from 0 to 0xffff sample at 8000 samples/second.
off-time controls the length of time between audible tones in milliseconds (ms) expressed as an
integer from 0 to 0xffff sample at 8000 samples/second.
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide (SCCP)
Optional Feature Parameters
5-21