Numtxframes; Udptos; Opflags - Cisco ATA 188 Administrator's Manual
Analog telephone adaptor
Hide thumbs
Also See for ATA 188:
- Administrator's manual (274 pages) ,
- Configuration (28 pages) ,
- Overview (11 pages)
Table of Contents
Advertisement
Chapter 5
Parameters and Defaults
Voice Configuration Menu Access Code
931
Related Parameters
•
•
NumTxFrames
Description
Not used for SCCP. For information about RTP packet size configuration, which is controlled by the
Cisco CallManager, refer to your Cisco CallManager documentation.
UDPTOS
Description
Use this parameter to specify the default IP precedence (ToS bit) of UDP packets. Set the lower eight
bits only, as follows:
•
•
•
•
•
Value Type
Bitmap
Default
0xB8
Voice Configuration Menu Access Code
255
OpFlags
Description
Use this parameter to enable/disable various operational features.
See
Value Type
Bitmap
Ol-3141-01
TftpURL, page 5-4
CA0orCM0 and CA1orCM1, page 5-9
Bits 0-1: Unused
Bit 2: Reliability bit—1=request high reliability
Bit 3: Throughput bit—1=request high throughput
Bit 4: Delay bit—1=request low delay
Bits 5-7: Specify datagram precedence. Values range from 0 (normal precedence) to 7 (network
control).
Table 5-3
for bit definitions of this parameter.
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide (SCCP)
Operating Parameters
5-17
Advertisement
Table of Contents
