Vlansetting - Cisco ATA 188 Administrator's Manual

Operating Parameters
Default
0x2
Voice Configuration Menu Access Code
323
Related Parameters
•
•
•
Table 5-3 OpFlags Parameter Operational Features to Turn On or Off
Bit Number Definition
0 If Bit 0 = 0, the TFTP configuration filename supplied by the DHCP server overwrites the default filename for
each Cisco ATA.
If Bit 0 = 1, the default Cisco ATA filename is always used.
1 If Bit 1 = 0, the Cisco ATA probes the static network router during the power-up process.
If Bit 1 = 1, static network router probing is disabled.
2 Reserved.
3 If Bit 3=1, the Cisco ATA does not request DHCP option 150 in the DHCP discovery message; some DHCP
servers do not respond if option 150 is requested.
4 If Bit 4 = 1, the Cisco ATA use the VLAN ID specified in the VLANSetting parameter for VLAN IP encapsulation
(see the "VLANSetting" section on page
5 If Bit 5=1, the Cisco ATA disables VLAN IP encapsulation.
6 If Bit 6=1, the Cisco ATA does not perform CDP discovery.
7 If Bit 7=1, the Cisco ATA does not allow web-based configuration.
8-10 Reserved.
11 If Bit 11=0, the Cisco ATA requests the device hostname from the DHCP server.
If Bit 11=1, the Cisco ATA uses the device hostname that is specified in DHCP option 12.
12-31 Reserved.

VLANSetting

Description
This parameter is used for specifying VLAN-related settings.
Bitmap definitions are as follows for the VLANSetting parameter:
•
•
•
•
•
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide (SCCP)
5-18
TftpURL, page 5-4
DHCP, page 5-6
VLANSetting, page 5-18
Bits 0-2—Specify VLAN CoS bit value (802.1 P priority) for TCP packets.
Bits 3-5—Specify VLAN CoS bit value (802.1 P priority) for UDP packets.
Bits 6-17—Reserved.
Bits 18-29—User-specified 802.1Q VLAN ID.
Bits 30-31—Reserved.
5-18).
Chapter 5 Parameters and Defaults
Ol-3141-01