Parameters And Defaults - Cisco ATA 188 Administrator's Manual

Parameters and Defaults

This section provides information on the parameters and defaults that you can use to create your own
Cisco ATA configuration file. This section also includes the voice configuration menu code for each
parameter that has such a code.
Some parameters on the Web Configuration screen are not used for SCCP; only those used for SCCP are
covered in this section.
Parameters are divided into categories based on their functionality. The following categories of
parameters are covered in this section:
User Interface (UI) Parameter, page 5-3
•
• Parameters for Configuration Method and Encryption, page 5-4
Network Parameters, page 5-6
•
Account Information Parameters, page 5-8
•
SCCP Mode Parameter, page 5-10
•
Operating Parameters, page 5-10
•
Optional Feature Parameters, page 5-19
•
The following list contains general configuration information:
Your configuration file must begin with #txt.
•
The Cisco ATA uses the following parameter types:
•
-
-
-
-
-
-
-
-
The term Cisco ATA is used throughout this manual to refer to both the Cisco ATA 186 and the
Note
Cisco ATA 188, unless differences between the Cisco ATA 186 and Cisco ATA 188 are explicitly stated.
Ol-3141-01
Alphanumeric string
Array of short integers
Boolean (1 or 0)
Bitmap value-unsigned hexadecimal integer (for specifying bits in a 32-bit integer)
Extended IP address-IP address followed by port number (for example, 192.168.2.170.9001)
IP address (e.g. 192.168.2.170)
Integer (32-bit integer)
Numeric digit string
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide (SCCP)
C H A P T E R
5
5-1