Chapter 2
Module Installation
To Pull the Optical Cable to the Module
1
Insert the Fiber Fish tool through the slot located just above the bottom of the
chassis.
2
At the rear of the chassis, locate the appropriate optical cable.
3
Insert the optical cable into the notched area of the Fiber Fish tool as shown
below.
4
At the front of the chassis, pull the Fiber Fish tool (with cable attached) to the
front of the chassis.
5
Disengage the optical cable from the Fiber Fish tool and attach to the appropriate
connector on the desired module.
Cable Routing - Prisma XD Chassis
Feed each fiber through the fiber tray located beneath the Prisma XD Chassis. The
fiber tray slides in and out to facilitate routing.
64