Cisco Prisma II Installation Manual page 166

Appendix A
Module Parameter Descriptions
Parameter ICIM
Name (LCI) Abbreviation
Rx Mode RxMode
1
RF Ports RxPorts
Node Select NodeSel
Parameter value can be modified by the user using the ICIM2 or ICIM2-XD, LCI software,
1
ROSA software, CLI commands, or the ICIM Web Interface.
164
Description
Sets the receiver operating mode
1
2.5GHz or 5GHz.
Note: Changing the Rx Mode forces
the FPGA to be reprogrammed.
This takes about 10 seconds, so user
may notice a delay before the
change takes effect.
Sets whether the RF output is gated
to both connectors or just the top
connector. Refer to block diagrams
in page 28.
Selects the node to be monitored
(Node 1 to Node 4)
Values Default
0: 5GHz 5GHz
1: 2.5GHz
1 1
2
1: Node 1 1
2: Node 2
3: Node 3
4: Node 4