To Connect Optical Cables To Module - Cisco Prisma II Installation Manual

To Connect Optical Cables to Module

Important: Observe laser safety precautions. Refer to Laser Safety information
earlier in this guide.
Note: This procedure assumes that the chassis is mounted in a rack and that the
optical cable has been installed at the node.
CAUTION:
The OPM is sensitive to electrostatic discharge. Always use an ESD strap or
similar individual grounding device when handling or coming into contact
with these modules.
CAUTION:
Removing and installing the OPM can shorten its useful life. Do not remove
and insert the OPM more often than absolutely necessary.
Complete the following steps for each optical cable to be connected to the module.
1 Select the appropriate OPM for the receiver from one of the following:

OPM P/N 4044008 for standard range

OPM P/N 4044009 for extended range
2 Remove the dust plugs from the OPM and save them for possible future use.
3 Line up the OPM with the optical input connector on the front of the receiver
and slide the OPM into the connector.
4 Insert the receiver end of the fiber optic connector into its receptacle on the OPM.
Connecting Optical Cables
65