Cisco Nexus 7000 Series Command Reference Manual page 55

Cisco Nexus 7000 Series NX-OS Quality of Service Commands
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m .
be-value
conform
transmit
set-prec-transmit
precedence-value
set-dscp-transmit
dscp-value
set-cos-transmit cos-val Sets the class of service (CoS) field to the specified value and transmits the
set-discard-class-trans
mit discard-class-value
set-qos-transmit
qos-group-value
exceed
drop
set dscp dscp table
cir-markdown-map
violate
set dscp dscp table
pir-markdown-map
Defaults bc default value is 200 milliseconds of traffic at the configured rate. The default data rate units are bytes.
be default value is 200 milliseconds of traffic at the configured rate. The default data rate units are bytes.
exceed default action is drop.
violate default action is drop.
Command Modes Policy map type qos class configuration
Supported User Roles
network-admin
vdc-admin
Command History Release
4.0
Usage Guidelines This command does not require a license.
OL-23378-01
Extended burst rate. If the bc value is not specified, the default is 200
milliseconds of traffic at the configured rate. The default data rate units are
bytes.
Sets the action to take when the data rate is within bounds.
Specifies the action of transmitting packets.
Sets the IP precedence field to the specified value and transmits the packet.
Valid values are from 0 to 7.
Sets the Differentiated Service Code Point (DSCP) field to the specified
value and transmits the packet. For a list of valid values for this field, see
Table 2.
packet. Valid values are from 0 to 7.
Sets the discard class field to the specified value and transmits the packet.
Valid values are from 0 to 63.
Sets the qos group field to the specified value and transmits the packet. Valid
values are from 0 to 126.
Sets the action to take when the data rate is exceeded. The default is drop.
Specifies the action of dropping packets.
Sets the DSCP field to the corresponding value in the system-defined table
map and transmits the packet.
Sets the action to take when the data rate violates the configured rate values.
The default is drop.
Sets the DSCP field to the corresponding value in the system-defined table
map and transmits the packet.
Modification
This command was introduced.
Cisco Nexus 7000 Series NX-OS Quality of Service Command Reference, Release 5.x
police (QoS)
QOS-45