Connect To The Network; Set A Password On Initial Phone Boot Up - Cisco 6841 User Manual

Connect to the Network

Procedure
Step 1
Remove the handset from the cradle and pull the plastic tab from the handset rest.
Step 2 Rotate the tab 180 degrees.
Step 3 Hold the tab between two fingers, with the corner notches facing you.
Step 4 Line up the tab with the slot in the cradle and press the tab evenly into the slot. An extension protrudes from
the top of the rotated tab.
Step 5 Return the handset to the handset rest.
Connect to the Network
You need to connect the phone to the telephone network.
• Wired connection—The phone is plugged into the network using an Ethernet cable.

Set a Password on Initial Phone Boot Up

The first time your phone boots up, you may be prompted to set a password. If you are not prompted, your
administrator has created a password for you.
Procedure
Step 1
Enter your password in the New password and Reenter new password fields.
Step 2 Press Save.
Cisco IP Phone 6800 Series Multiplatform Phones User Guide
4
Your Phone