Cisco 1003 User Manual page 35

Configure the serial (BRI) port. Respond to the prompts as follows, substituting
Step 5
the correct IP address in the appropriate location:
Configuring interface BRI0:
Is this interface in use? [yes]:
Configure IP on this interface? [yes]:
IP address for this interface: 172.16.21.15
Number of bits in subnet field [0]:
Class B network is 172.16.0.0, 8subnet bits; mask is 255.255.255.0
Step 6 At this point, the setup program displays the values you entered, and you are asked
if you want to use the displayed configuration. If you answer yes, this
configuration will be entered and saved in the configuration database and stored in
NVRAM. If you answer no, you can begin the configuration again and make any
changes you want.
The following configuration command script was created:
hostname router1
enable secret 5 $1$KL/H$AC/fCdkgU.WOBybZnUqPe/
enable password ron
line vty 0 4
password karen
snmp-server community public
!
ip routing
no appletalk routing
no ipx routing
isdn switch-type none
!
interface Ethernet0
ip address 172.16.20.11 255.255.255.0
!
interface BRI0
ip address 172.16.21.15 255.255.255.0
!
router igrp 1
network 172.16.0.0
!
end
Use this configuration? [yes/no]: yes
####
Configuring Your Cisco 1003 or Cisco 1004 Router
Cisco 1003 and Cisco 1004 User Guide 35