Using The Setup Program - Cisco 1003 User Manual

Using the Setup Program

If a configuration file is not available for your router, you must enter the interface addresses
and global parameters using the setup program. Obtain the IP address and the number of
bits in the subnet field of the Ethernet and BRI port from your system administrator before
proceeding with the procedure described in this section.
The following procedure explains how to manually configure the router:
Step 1
Note
1 stop bit.
Step 2
Connect a console terminal to the console port on the rear panel of your router, and
connect the power to the power port on the rear panel.
The default parameters for the console port are 9600 baud, 8 data bits, no parity, and
After about 30 seconds, the following information displays on the console screen.
When you see the following information, you have successfully booted your
router:
Copyright (c) 1994-1995 by cisco Systems, Inc.
C1000 processor with 4096 Kbytes of main memory
program load complete, entry point: 0xXXXXX, size: 0xXXXXX
Notice: NVRAM invalid, possibly due to write erase.
program load complete, entry point: 0xXXXXXXX, size: 0xXXX
Uncompressing file:
###################################################################
###################################################################
###################################################################
###################################################################
###################################################################
################
program load complete, entry point: 0xXXXXXXX, size: 0xXXXXXX
Restricted Rights Legend
Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
Configuring Your Cisco 1003 or Cisco 1004 Router
Cisco 1003 and Cisco 1004 User Guide 31