Cisco 1003 User Manual page 28

Installing Your Cisco 1003 or Cisco 1004 Router
Step 2
Checking the Router Installation
After you finish installing your router, attempt to send data and check the LEDs on the front
panel to verify that everything is working properly.
To verify that your router is working properly, follow these steps:
Step 1
Step 2
28 Cisco 1003 and Cisco 1004 User Guide
Connect the power supply to the power outlet. Plugging in the power supply turns
on power to the router.
Wall-mount
Power outlet
power supply
Verify that the LED labeled POWER is on steadily, and the LED labeled SYSTEM
OK is on when the router is plugged into the power source. The SYSTEM OK
LED will be on or blinking depending on the boot state of the router. When these
LEDs are on, it indicates that the router is receiving power and that it has passed
internal diagnostic tests.
Verify that the LEDs labeled LAN TX (Ethernet transmit) and LAN RX (Ethernet
receive) are flickering. This flickering indicates that there is Ethernet traffic on the
LAN connection. A lack of flickering may indicate a problem with the unit, or may
indicate that there is no traffic on the LAN.
DC power input
12VDC