Honda ACCORD HYBRID 2005 Service Manual page 569

9. Turn the ignition switch OFF.
10. J u m p the SCS line w i t h the HDS.
11. Disconnect PCM connector D (17P).
12. Check for continuity between A/C pressure sensor
3P connector terminal No. 2 and body ground.
A / C P R E S S U R E S E N S O R 3P CONNECTOR
ACPD (GRN)
Wire side of female terminals
Is there continuity?
Y E S — R e p a i r short in the w i r e between the PCM
(D17) and the A/C pressure sensor, then go to step
15.
NO—Go to step 20.
13. Turn the ignition switch OFF.
14. Replace the A/C pressure sensor.
15. Reconnect all connectors.
16. Turn the ignition switch ON (II).
17. Reset the PCM w i t h the HDS.
18. Do the PCM idle learn procedure (see page 11-340).
19. Check for Temporary DTCs or DTCs w i t h the HDS.
Are any Temporary DTCs or DTCs indicated?
Y E S — I f DTC P0532 is indicated, check for poor
connections or loose terminals at the A/C pressure
sensor and the PCM, then go to step 1. If any other
Temporary DTCs or DTCs are indicated, go to the
indicated D T C s troubleshooting.
NO—Troubleshooting is complete. •
20. Update the PCM if it does not have the latest
software, or substitute a known-good PCM
(see page 11-6).
2 1 . Check for Temporary DTCs or DTCs w i t h the HDS.
Are any Temporary DTCs or DTCs indicated?
Y E S - l f DTC P0532 is indicated, check for poor
connections or loose terminals at the A/C pressure
sensor and the PCM, then go to step 1. If any other
Temporary DTCs or DTCs are indicated, go to the
indicated D T C s troubleshooting.
NO—If the PCM was updated, troubleshooting is
complete. If the PCM was substituted, replace the
original PCM (see page 11-219). •
11-329