Honda ACCORD HYBRID 2005 Service Manual page 212

Engine Lubrication
O i l P u m p O v e r h a u l ( c o n t ' d )
Special Tools Required
Oil seal driver, 64 m m 070AD-RCA0100
Removal
1. Drain the engine oil (see page 8-7).
2. Turn the crankshaft so that the No. 1 piston is at top
dead center (TDC) (see page 6-16).
3. Remove the t i m i n g belt (see page 6-16).
4. Remove the idler pulley.
5. Remove the crankshaft position (CKP) sensor
(see page 11-216).
6. Remove the oil filter base/oil filter assembly (see
step 8 on page 7-13).
7. Remove the oil pan (see page 7-11).
8. Remove the oil screen (A).
9. Remove the m o u n t i n g bolts and the oil p u m p
assembly (B).
Inspection
1. Remove the screws f r o m the p u m p housing, then
separate the housing and cover.
2. Check the inner-to-outer rotor radial clearance
between the inner rotor (A) and outer rotor (B). If
the inner-to-outer rotor clearance exceeds the
service limit, replace the oil p u m p assembly.
Inner Rotor-to-Outer Rotor Radial Clearance
Standard (New): 0.04—0.16 mm (0.002—0.006 in.)
Service Limit: 0.20 mm (0.008 in.)
3. Check the housing-to-rotor axial clearance between
the rotors (A) and p u m p housing (B). If the housing-
to-rotor axial clearance exceeds the service limit,
replace the oil p u m p assembly.
Housing-to-Rotor Axial Clearance
Standard (New): 0 . 0 2 - 0 . 0 7 m m (0.001-0.003 in.)
Service Limit: 0.12 mm (0.005 in.)
8-12