Honda ACCORD HYBRID 2005 Service Manual page 164

Cylinder Head
C y l i n d e r H e a d I n s t a l l a t i o n ( c o n t ' d )
7. A p p l y new engine oil to the threads and flanges of
the cylinder head bolts.
8. Tighten the cylinder head bolts sequentially in
three steps.
NOTE: Perform each step t w i c e .
1st Step Torque: 39 N-m (4.0 kgf-m, 29 Ibfft)
2nd Step Torque: 69 N-m (7.0 kgf-m, 51 Ibfft)
3rd Step Torque: 98.1 N-m (10.0 kgf m, 72.3 Ibfft)
Use a beam-type t o r q u e w r e n c h . W h e n using a
preset-type t o r q u e w r e n c h , be sure to tighten
s l o w l y and not t o overtighten. If a bolt makes any
noise w h i l e y o u are t o r q u i n g it, loosen the bolt, and
retighten it f r o m the 1st step.
FRONT:
® ® ® ®
© © ® ®
REAR:
© ® ® ®
© © ® ©
9. Install the water passage (see page 10-9).
10. Install the fuel rails (see step 8 on page 11-212).
11. Install the connector bracket to the f r o n t cylinder
head.
1 0 x 1 . 2 5 m m
22 N-m (2.2 kgf-m, 16 Ibfft)
12. install the harness c l a m p bracket to the rear
cylinder head.
8 x 1.25 m m
22 N m (2.2 k g f - m , 16 Ibfft)
6-62