Honda ACCORD HYBRID 2005 Service Manual page 526

Active Control Engine Mount (ACM) System
D T C T r o u b l e s h o o t i n g ( c o n t ' d )
DTC P0A15: Front Engine Mount Actuator
Control Circuit Low Current
DTC P0AB7: Rear Engine Mount Actuator
Control Circuit Low Current
NOTE: Information marked w i t h an asterisk (*) applies
to rear active control engine mount (ACM) actuator.
1. Turn the ignition switch ON (II).
2. Clear the DTC w i t h the HDS.
3. Start the engine, and let it idle 10 seconds.
4. Check for Temporary DTCs or DTCs w i t h the HDS.
Is DTC P0A15 and/or P0AB7* indicated?
Y E S — G o t o step 5.
IMO—Intermittent failure, system is OK at this time.
Check for poor connections or loose terminals at
the engine mount control unit and the active
control engine m o u n t (ACM) actuator or the engine
mount control unit and G302. •
7. Check the resistance between front (rear)* active
control engine mount (ACM) actuator 2P connector
terminals No. 1 and No. 2.
ACTIVE CONTROL ENGINE M O U N T (ACM)
A C T U A T O R 2P CONNECTOR
1 2
Terminal side of male terminals
Is there about 0.75- 1.15 Q,?
Y E S — G o t o step 8.
NO—Replace the front engine m o u n t (see page
5-22) or rear engine mount (see page 5-24)*, then
go to step 13.
5. Turn the ignition switch OFF.
6. Disconnect the front (rear)* active control engine
mount (ACM) actuator 2P connector.
11-286