Ip Access Lists; Zone Default Policy; Fc-Redirect; Fc-Redirect Unsupported Switches - Cisco MDS 9000 series Configuration Manual

IP Access Lists

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
To globally enable CFS distribution on a switch, follow these steps:
Command
Step 1
switch# config t
switch(config)#
Step 2
switch(config)# cfs distribute
For more information about CFS, refer to the Cisco MDS 9000 Family NX-OS System Management
Configuration Guide.

IP Access Lists

Cluster communication requires the use of the Management interface. IP ACL configurations must allow
UDP and TCP traffic on ports 9333, 9334, 9335, and 9336.

Zone Default Policy

For FC-Redirect to work correctly, the default zone policy on all the switches in the IOA environment
must be configured to deny and the initiator-target pairs must be configured in user-defined zones.

FC-Redirect

This section includes the following topics:
•
•

FC-Redirect Unsupported Switches

FC-Redirect is not supported on the following switches, which also means that IOA is not supported:
•
•
•
•
•
•

FC-Redirect Requirements

FC-Redirect requirements for IOA include the following:
•
Cisco MDS 9000 Family I/O Accelerator Configuration Guide
2-2
FC-Redirect Unsupported Switches, page 2-2
FC-Redirect Requirements, page 2-2
Cisco MDS 9148 Switch
Cisco MDS 9140 Switch
Cisco MDS 9134 Switch
Cisco MDS 9124 Switch
Cisco MDS 9120 Switch
Cisco MDS 9020 Switch
The MDS switch with the MSM-18/4 Module installed or the 9222i Switch needs to be running
Cisco MDS NX-OS Release 4.2(1) or later.
Purpose
Enters configuration mode.
Enables (default) CFS distribution on the switch.
OL-20708-01, Cisco MDS NX-OS Release 5.0(1a)
Chapter 2 Getting Started