Adding Nodes To An Ioa Cluster - Cisco MDS 9000 series Configuration Manual

Configuring an IOA Cluster
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Cluster Infra Status : Operational
Cluster is Administratively Up
Cluster Config Version : 26
SSL for ICN : Not Configured
sjc-sw2# show ioa cluster tape_vault
IOA Cluster is tape_vault
Cluster ID is 0x213a000dec3ee782
Cluster status is online
Is between sites SJC and RTP
Total Nodes are 2
Cluster Infra Status : Operational
Cluster is Administratively Up
Cluster Config Version : 26
SSL for ICN : Not Configured
A cluster can have the following statuses:
•
•
•
The infrastructure status has following values:
•
•
The administrative status has following values:
•
•

Adding Nodes to an IOA Cluster

To add nodes to an IOA cluster, perform this task:
Command
Step 1
sjc-sw2# config t
switch(config)#
Step 2
sjc-sw2(config)# ioa cluster
tape_vault
sjc-sw2(config-ioa-cl)#
Cisco MDS 9000 Family I/O Accelerator Configuration Guide
4-6
Pending—An IOA interface needs to be added to the cluster.
Online—The cluster is online. IOA services can be run on the cluster.
Offline—The cluster is offline. Check the infrastructure status for more information.
Operational—The cluster infrastructure is operational on this switch. The IOA service will be able
to use the cluster on this switch.
Not Operational—The cluster infrastructure is not operational on this node. The IOA service will
not run on this cluster on this switch.
Administratively Up—If the cluster is not online, check this status to make sure that administratively
the cluster is up.
Administratively Shutdown—The cluster was shut down.
Purpose
Enters configuration mode.
Enters the cluster configuration submode and adds the local
switch where this command is executed into the IOA cluster.
Chapter 4 Configuring IOA Using the CLI
OL-20708-01, Cisco MDS NX-OS Release 5.0(1a)