Add Switch2 Node With New Description And The Ip Address; Add Ioa Interfaces On Switch2; Verify The Node Description And Ip Address And Flows - Cisco MDS 9000 series Configuration Manual

Additional Configurations
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Change the Management Interface IP Address on Switches
sw-231-19(config)# int mgmt0
sw-231-10(config-if)# ip address 172.25.231.19 255.255.255.0
sw-231-19(config)# int mgmt0
sw-231-10(config-if)# ip address 172.25.231.25 255.255.255.0
Change the Node Description and IP Address on switch1
Change the node description and IP address on the switch1 using the command node id id
new-description ip-address new-ip address
sw-231-19(config-ioa-cl)# node id 1 192.125.231.72 ip-address 192.125.231.72
No Shut Down IOA Cluster on switch1
To shut down the IOA cluster on a switch, follow these steps:
sw-231-19(config-ioa-cl-node)# no sh
This change can be disruptive. Please ensure you have read the "IOA Cluster Recovery
Procedure" in the configuration guide. -- Are you sure you want to continue? (y/n) [n] y
sw-231-19(config-ioa-cl)# 2011 Apr 12 07:04:54 sw-231-19
%CLUSTER-2-CLUSTER_LEADER_ANNOUNCE: Node 0x1 is the new Master of cluster
0x5000530019f08076 of 1 nodes
2011 Apr 12 07:04:54 sw-231-19 %CLUSTER-2-CLUSTER_QUORUM_GAIN: Cluster 0x5000530019f08076
now has quorum with 1 nodes
sw-231-19(config-ioa-cl)# show ioa cluster
-------------------------------------------------------------------------------
Switch
-------------------------------------------------------------------------------
192.125.231.72(L)

Add switch2 Node with New Description and the IP Address

To add switch2 node with new description and IP address, follow these steps
sw-231-19(config-ioa-cl)# node 172.25.231.25
2011 Apr 12 07:05:30 sw-231-19 %CLUSTER-2-CLUSTER_QUORUM_GAIN: Cluster 0x5000530019f08076
now has quorum with 1 nodes
2011 Apr 12 07:05:30 sw-231-19 %CLUSTER-2-CLUSTER_QUORUM_GAIN: Cluster 0x5000530019f08076
now has quorum with 2 nodes

Add IOA Interfaces on switch2

To add IOA interfaces on the switch, follow these steps:
sw-231-19(config-ioa-cl-node)# int ioa 1/1
sw-231-19(config-ioa-cl-node)# int ioa 1/2
sw-231-19(config-ioa-cl-node)#

Verify the Node Description and IP Address and Flows

Use the following show commands to confirm the functioning of the cluster with the new IP address:
Cisco MDS 9000 Family I/O Accelerator Configuration Guide
4-20
Site Status
site2 online
Chapter 4
c1 node summary
Master Node ID
yes 1
OL-20708-01, Cisco MDS NX-OS Release 5.0(1a)
Configuring IOA Using the CLI