Adding N Ports To An Ioa Cluster - Cisco MDS 9000 series Configuration Manual

Chapter 4 Configuring IOA Using the CLI
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
172.23.144.97(L)
172.23.144.97(L)
172.23.144.98
172.23.144.98
sjc-sw2# show ioa cluster tape_vault interface
Interface ioa2/1 belongs to 172.23.144.97(L)(M)
Status is up
Interface ioa2/2 belongs to 172.23.144.97(L)(M)
Status is up
Interface ioa2/1 belongs to 172.23.144.98
Status is up
Interface ioa2/2 belongs to 172.23.144.98
Status is up
Note

Adding N Ports to an IOA Cluster

To add N ports to the IOA cluster, perform this task:
Command
Step 1
sjc-sw2# config t
sjc-sw2(config)#
Step 2
sjc-sw2(config)# ioa cluster
tape_vault
Step 3
sjc-sw2(config-ioa-cl)# nport
pwwn 10:0:0:0:0:0:0:1 site SJC
vsan 100
sjc-sw2(config-ioa-cl)# nport
pwwn 11:0:0:0:0:0:0:1 site RTP
vsan 100
sjc-sw2(config-ioa-cl)# nport
pwwn 10:0:0:0:0:0:0:2 site SJC
vsan 100
sjc-sw2(config-ioa-cl)# nport
pwwn 11:0:0:0:0:0:0:2 site RTP
vsan 100
sjc-sw2(config-ioa-cl)# end
sjc-sw2(config-ioa-cl)# no
nport pwwn 10:0:0:0:0:0:0:1
This example shows how to display N ports configuration:
sjc-sw2# show ioa cluster tape_vault nports
-------------------------------------------------------------------------------
P-WWN
-------------------------------------------------------------------------------
10:00:00:00:00:00:00:01
11:00:00:00:00:00:00:01
10:00:00:00:00:00:00:02
11:00:00:00:00:00:00:02
OL-20708-01, Cisco MDS NX-OS Release 5.0(1a)
ioa2/1
ioa2/2
ioa2/1
ioa2/2
( L) indicates the Local switch.
(M) indicates the Master switch.
up --
up --
up --
up --
Purpose
Enters configuration mode.
Enters the cluster configuration submode.
Configures the site and VSAN ID of the N ports that will be a part
of accelerated flows.
Removes the N port from the IOA cluster.
Site
SJC
RTP
SJC
RTP
Cisco MDS 9000 Family I/O Accelerator Configuration Guide
Configuring an IOA Cluster
Vsan
100
100
100
100
4-9