Cisco MDS 9000 series Configuration Manual page 57

Chapter 4 Configuring IOA Using the CLI
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Command
Step 3
sjc-sw2(config-ioa-cl)# node
local
sjc-sw2(config-ioa-cl)# node
sjc-sw2
sjc-sw2(config-ioa-cl-node)#
end
sjc-sw2(config-ioa-cl)# node
rtp-sw2
sjc-sw2(config-ioa-cl-node)#
end
sjc-sw2(config-ioa-cl)# no
node rtp-sw2
The following examples display the nodes information:
sjc-sw2# show ioa cluster summary
-------------------------------------------------------------------------------
Cluster
-------------------------------------------------------------------------------
tape_vault
sjc-sw2# show ioa cluster tape_vault node summary
-------------------------------------------------------------------------------
Switch
-------------------------------------------------------------------------------
172.23.144.97(L)
172.23.144.98
sjc-sw2# show ioa cluster tape_vault node
Node 172.23.144.97 is local switch
Node ID is 1
Status is online
Belongs to Site SJC
Node is the master switch
Node 172.23.144.98 is remote switch
Node ID is 2
Status is online
Belongs to Site RTP
Node is not master switch
OL-20708-01, Cisco MDS NX-OS Release 5.0(1a)
Purpose
Enters the node configuration submode for the local switch. The
local keyword denotes the switch where the CLI command is
executed.
Note
Includes the switch as part of the cluster. Enters the node config-
uration submode.
Includes the remote switch as part of the cluster. Alternatively,
use an IPv4 or IPv6 address. Enters the node configuration
submode.
Removes the local or the remote node from the cluster.
Sites Status
SJC, online
RTP
Site Status
SJC online
RTP online
Cisco MDS 9000 Family I/O Accelerator Configuration Guide
You may also specify the node name of the local
switch to enter sub mode. The node name could be
either the IP Address or the DNS name of the local
switch.
Master Switch
172.23.144.97
Master
yes
no
Configuring an IOA Cluster
4-7