Draytek VIGOR2860 series User Manual page 874

del
filter
show [0/1/2/3]
E x a m p l
E x a m p
>
wl scan set wlist 001122aabbcc
>
wl scan start
>
wl scan show 3
>
T e l n e t C o m m
T e l n e t C o m m
This command is used to configure connection time and reconnection time for each SSID that
wireless client used for accessing into Internet.
S y n t a x
S y n t a x
wl stamgt [enable/disable] [ssid_num].
wl stamgt [show] [ssid_num].
wl stamgt set [ssid_num] [c] [r]
wl stamgt reset [ssid_num].
S y n t a x
S y n t a x
Parameter
enable/disable
ssid_num
show
c
r
E x a m p l
E x a m p
> wl stamgt enable 1
% Station Management Status: enabled
> wl stamgt set 1 60 60
> wl stamgt show 1
NO. SSID
1. Draytek
858
Remove white list/block list.
e.g., wl scan del wlist 001122aabbcc
Set which filter you want.
ssid – scanning the AP based on SSID setting.
channel - scanning the AP based on channel setting.
mac - scanning the AP based on MAC address setting..
It is used to show AP list.
0 - display white list
1 - display block list,
2 - display gray/unknown list,
3 - display all list
e
l e
a n d : w l s t a m g t
a n d : w l s t a m g t
D e s c r i p t i o n
D e s c r i p t i o n
Description
It means to enable/disable the station management control.
It means channel selection.
Available channel for 2.4G: 0/1/2/3
Available channel for 5G: 4/5/6/7.
It means to display status or configuration of the selected channel.
It means connection time. The unit is minute.
It means reconnection time. The unit is minute.
e
l e
BSSID
00:11:22:aa:bb:cc
Connect time Reconnect time
0d:0:58:26 0d:0:0
Vigor2860 Series User's Guide