Draytek VIGOR2860 series User Manual page 112

After finishing all the settings here, please click OK to activate them.
I I - 1 - 2 - 6 D
I I - 1 - 2 - 6 D
E t h e r n e t
E t h e r n e t
For static IP mode, you usually receive a fixed public IP address or a public subnet, namely
multiple public IP addresses from your DSL or Cable ISP service providers. In most cases, a
Cable service provider will offer a fixed public IP, while a DSL service provider will offer a
public subnet. If you have a public subnet, you could assign an IP address or many IP address
to the WAN interface.
To use Static or Dynamic IP as the accessing protocol of the internet, please click the Static
or Dynamic IP tab. The following web page will be shown.
96
e t a i l s P a g e f o r S t a t
e t a i l s P a g e f o r S t a t
)
)
whenever you request. In this case, you can fill in this IP
address in the Fixed IP field. Please contact your ISP before
you want to use this function.
WAN IP Alias - If you have multiple public IP addresses and
would like to utilize them on the WAN interface, please use
WAN IP Alias. You can set up to 32 public IP addresses other
than the current one you are using. Type the additional WAN
IP address and check the Enable box. Then click OK to exit
the dialog.
Fixed IP – Click Yes to use this function and type in a fixed IP
address in the box of Fixed IP Address.
Default MAC Address – You can use Default MAC Address or
specify another MAC address by typing on the boxes of MAC
Address for the router.
Specify a MAC Address – Type the MAC address for the router
manually.
i c o r D y n a m i c I P i n
i c o r D y n a m i c I P i n
W A N 2 ( P h y s i c a l M o
W A N 2 ( P h y s i c a l M o
Vigor2860 Series User's Guide
d e :
d e :