Draytek VIGOR2860 series User Manual page 300

Item
Operation Mode
Channel Bandwidth
Guard Interval
Aggregation MSDU
Number of Spatial Streams
(NSS)
Long Preamble
Packet-OVERDRIVE
284
Description
Mixed Mode – the router can transmit data with the ways
supported in both 802.11a/b/g and 802.11n standards.
However, the entire wireless transmission will be slowed
down if 802.11g or 802.11b wireless client is connected.
Green Field – to get the highest throughput, please choose
such mode. Such mode can make the data transmission
happen between 11n systems only. In addition, it does not
have protection mechanism to avoid the conflict with
neighboring devices of 802.11a/b/g.
20- the router will use 20Mhz for data transmission and
receiving between the AP and the stations.
40- the router will use 40Mhz for data transmission and
receiving between the AP and the stations.
20/40 – the router will use 20Mhz or 40Mhz for data
transmission and receiving according to the station
capability. Such channel can increase the performance for
data transit.
20/40/80 – the router will use 20Mhz, 40Mhz or 80Mhz for
data transmission and receiving according to the station
capability. Such channel can increase the performance for
data transit.
It is to assure the safety of propagation delays and
reflections for the sensitive digital data. If you choose auto
as guard interval, the AP router will choose short guard
interval (increasing the wireless performance) or long guard
interval for data transmit based on the station capability.
Aggregation MSDU can combine frames with different sizes
It is used for improving MAC layer's performance for some
brand's clients. The default setting is Enable.
Setup Number of Spatial Stream for Vigor2860ac and
Vigor2860Vac.
Default value is 2 and connection rate could reach 1.3GBps.
This option is to define the length of the sync field in an
802.11 packet. Most modern wireless network uses short
preamble with 56 bit sync field instead of long preamble with
128 bit sync field. However, some original 11b wireless
network devices only support long preamble. Click Enable to
use Long Preamble if needed to communicate with this kind
of devices.
This feature can enhance the performance in data
transmission about 40%* more (by checking Tx Burst). It is
active only when both sides of Access Point and Station (in
wireless client) invoke this function at the same time. That
is, the wireless client must support this feature and invoke
the function, too.
Note: Vigor N61 wireless adapter supports this function.
Therefore, you can use and install it into your PC for
matching with Packet-OVERDRIVE (refer to the following
picture of Vigor N61 wireless utility window, choose Enable
for TxBURST on the tab of Option).
Vigor2860 Series User's Guide
.