Establishing Usb Communication - Honeywell dolphin 75e User Manual

4. Insert the Dolphin into the terminal well. The Dock LED on the base illuminates blue.
5. Touch All Apps
6. Touch Ethernet and verify the switch button is On
When an Ethernet connection is established the status icon changes from
Troubleshooting
If the items on the Ethernet configuration screen are grayed out and not accessible, verify the base has power, the
Ethernet cable is undamaged and properly installed to the base, there is an active network signal over the Ethernet
cable, and the terminal is properly docked in the base.
Ethernet Configuration Settings
Instead of using the default DHCP assigned IP address, the Dolphin terminal can be configured to use a statically
assigned IP address.
1. Touch All Apps
2. Select Ethernet configuration.
3. Touch DHCP, and then select Static.
4. Input the IP address and any additional information based on your network configuration.
5. Touch Save.
Ethernet Proxy Settings
To set up a proxy to use when accessing your network with Ethernet:
1. Touch All Apps
2. Select Proxy.
3. Input the Proxy host name and Proxy port. If required, designate when to bypass the proxy.
4. Select Done.
Displaying the eBase and Terminal IP Address
Once the Dolphin terminal has been successfully connected to the network through eBase, the terminal uses the
eBase IP address. The IP address can be used by any application on the Dolphin terminal.
Touch All Apps

Establishing USB Communication

Dolphin terminals support USB communications out of the box. The base also supports USB communications via the USB
port located on the back. The base acts as a USB device by interfacing the USB signals of the Dolphin terminal to the USB
of the host workstation. Using a standard USB cable, the base's USB interface allows the Dolphin terminal to communicate
with a workstation.
Note: This base cannot be daisy-chained.
Requirements
• A base powered by a power cable and power adapter cable
• A standard USB (Type A to B) communication cable
• A workstation running Windows XP, Windows Vista, Windows 8, Windows 7, Windows 8 or Windows 10.
9 - 6
> Settings .
> Settings > Ethernet.
> Settings > Ethernet.
> Settings > About Phone > Status to view the assigned IP Address.
.
to at the top of the screen.