Configuring The Scan Demo Application; Using The Demo To Save A Picture For Troubleshooting - Honeywell dolphin 75e User Manual

Continuous Scanning
Enable Continuous scanning mode to activate the imager for continuous scanning only when the operator touches
and holds Scan or presses and holds the Scan button. The time interval between scan attempts is minimal and not
configurable.
1. Slide the Continuous blue button to the ON position to enable the feature.
2. Touch and hold Scan or press and hold the Scan button to activate the imaging engine.
The imager scans and decodes bar codes presented in the terminal's field of view as long as Scan or the Scan but-
ton is pressed.
3. Release Scan or the Scan button to deactivate the imager.
4. Slide the Continuous blue button to the OFF position to disable the feature.

Configuring the Scan Demo Application

1. Open the Scan Demo application, and then touch the three dots
2. Select Scan Settings, Symbology Settings, or Notification Settings.
3. Modify the settings to meet your application needs, and then touch
Scan Settings
Touch the check box to enable or disable a feature. A check mark indicates enabled.
Setting
View Statistics
Auto Scan Delay
Auto Send
RF Configuration
Symbology Settings
For information on these settings,
Notification Settings
For information on these settings,

Using the Demo to Save a Picture for Troubleshooting

If a bar code is producing errors and you need to supply an image of the code to a support representative for
troubleshooting purposes, you can use the Scan Demo to capture a JPG of the bar code using the camera.
1. Open the Scan Demo application, and then touch the three dots
2. Touch Capture Error Barcode.
3. Point the camera lens (located on the back of the terminal) at the bar code.
4. Touch the camera
3 - 8
Description
When enabled, scan results include the length of bar code, the number of
scans completed, the number of milliseconds (ms) to decode the bar
code, the average decode time of all the bar codes decoded, the shortest
decode time of all bar codes decoded, and the longest decode time of all
bar codes decoded.
Program the number of seconds between scan attempts by tapping the
menu arrow, and then entering the delay interval in second. The value
should be greater than 0 and less than 100000. Touch OK to save.
When enabled, decoded data is sent to a designated server.
Touch to view and/or edit the Server IP address and the Port used for RF
communication. When the Back button is pressed, the terminal attempts
to establish communication.
Symbology Settings
Notification Settings
to capture the image.
in the upper right corner of the screen.
to return to the Scan Demo screen.
on page 3-8.
on page 3-6.
in the upper right corner of the screen.
Default Value
Enabled
1
Disabled