Selection Of Input Type And Output 1 Type - Honeywell DCP 50 Product Manual

Figure 7-3
7.5

SELECTION OF INPUT TYPE AND OUTPUT 1 TYPE

The selection of input type and Output 1 type is accomplished on link jumpers on the
CPU PCB. The CPU PCB may be either of two forms: (a) for a relay, solid state or SSR
drive Output 1 (see Figure 7-4) or for a DC Output 1 (see Figure 7-5).
7.5.1 Input Type
The required input type is selected on
link jumpers LJ1/LJ2/LJ3 on the CPU PCB
(see Figure 7-4 or 7-5, as appropriate,
and Table 7-1).
7-4
Removing the RS485 Communications Option PCB
or the Remote Run/Hold Option PCB
Table 7-1 Selection of Input Type
Input Type
RTD or DC (mV)
Thermocouple
DC (mA)
DC (V)
Link Jumpers Fitted
None (Parked)
LJ3
LJ2
LJ1