Honeywell DCP 50 Product Manual page 46

B. Word Parameters
No.
Controller Parameters
1 Process Variable
2 Setpoint
3 Output Power
4 Arithmetic Deviation
5 Proportional Band 2
6 Proportional Band 1
7 Controller Status
8 Reset
9 Rate
10 Output 1 Cycle Time
11 Scale Range Low
12 Scale Range High
13 Alarm 1 value
14 Alarm 2 value
15 Manual Reset
16 Overlap/Deadband
17 ON/OFF Differential
18 Decimal Point Position
19 Output 2 Cycle Time
20 Output 1 Power Limit
21 Setpoint Lock
22 Reserved
23 Filter Time Constant
24 Process Variable Offset
25 Recorder Output Max.
26 Recorder Output Min.
27 Alarm 1 Hysteresis
28 Alarm 2 Hysteresis
Program Parameters
29 Segment Mode
30 Profiler Status
5-8
Parameter Notes
Read only
Current setpoint, if ramping
Read only, unless in Manual Control
Read only
Read only if non-linear input
Read only if non-linear input
Read only if non-linear input
0 = Off, 1 = On
0 = Rate, 1 = Time
Read only - see Subsection 5.5.