Connections And Wiring - Honeywell DCP 50 Product Manual

The procedure to panel-mount the Controller Programmer is shown in Figure 2-3.
CAUTION: Do not remove the panel gasket, as this may result in
inadequate clamping of the instrument in the panel.
NOTE: When installing several Programmer Controllers side-by-side in
one cut-out, use the ratchets on the top/bottom faces.
Figure 2-3
Once the Controller is installed in its mounting panel, it may be subsequently
removed from its housing, if necessary, as described in Subsection 7.1.
2.3

CONNECTIONS AND WIRING

The rear terminal connections are illustrated in Figure 2-4.
WARNING ! This instrument is designed for installation in an
enclosure which provides adequate protection aganist electric
shock. All pertinent local regulations should be rigidly observed.
Consideration should be given to prevention of access to the
rear terminals by unauthorised personnel. Disregard for these
instructions may cause injury or death!
2-2
Panel-Mounting the Controller Programmer