Drive Settings - Siemens SINAMICS S120 Commissioning Manual

• p2006: Reference temperature
• p2007: Reference acceleration
Correct defaults
You can correct the default settings for all p parameters in the table: Proceed as follows:
1. Click in the "Values" field for the corresponding reference parameter.
2. Enter the desired new value.
3. Repeat steps 1 and 2 for the other reference parameters whose default settings you want to
change.
4. Finally, save the project.
5.7.3.6

Drive settings

Overview
No entries are required on this page for motors with DRIVE-CLiQ interface or motors of the motor
database.
Requirements
• You have completely specified and configured the motor used in the device configuration of
the drive axis.
Note
This basic parameterization cannot be performed without having completed this full
configuration.
Commissioning with Startdrive
Commissioning Manual, 06/2020, 6SL3097-5AA10-0BP2
5.7 Basic parameterization of the drive objects
Commissioning
215