Siemens SIPROTEC 5 Manual page 221

[scrouins-280113-01.tif, 1, en_US]
Figure 7-9
NOTE
i
i
Use a maximum of 57 characters
because these prevent healthy export to SICAM PQS and into file formats such as COMTRADE and PQDIF .
The channel name is truncated if the permissible length is exceeded.
Connecting Function Groups
You can use the Function-group connections matrix to edit the connections between the function groups
and measuring points.
Connect each measuring point with the corresponding function group in the Connecting measuring
²
points with function group window.
If the cells of the measuring point line and the target column is light gray, then the measuring point is
routed to the column.
If the joint cell is dark gray, the measuring point cannot be routed to the relevant column.
If the cell is red, this indicates an inconsistency. You must route the measuring point to the affected
column.
Click X (Routed) in the context menu in the red markers.
²
An X is entered into the cell. The measuring point is not connected to the function group.
5 128 initial characters of the US-ASCII/ANSI character set
SIPROTEC 5, Fault Recorder, Manual
C53000-G5040-C018-5, Edition 11.2017
Instantiating Recorder Routing with the Respective Function Blocks
5 for the channel name. Do not use either umlauts or special characters,
Fault Recorder
7.1 Introduction to DIGSI 5
221