Figure 4-19 Dc Plug Mts 2 (Motorola P/N 3166501A01) - Blue/Black Wires - Motorola DIMETRA MTS 2 Installation, Configuration And Basic Service Manual

MTS 2 and MTS 4 Installation, Configuration and Basic Service Manual
Procedure 4-6 How to Connect –48 VDC Power Source to Equipment Cabinet
1
Route two runs of bulk wiring between the MTS DC input connector and the facility power
2
supply -48 VDC connections.
Make sure that the wire runs are properly routed to the cabinet, allowing adequate slack.
3
Connect the free ends of the wire to the MTS DC plug, which is provided with the MTS.
4
Following the industry standard for positive earth systems unless local regulations state
something different:
Figure 4-19 DC Plug MTS 2 (Motorola P/N 3166501A01) – Blue/Black Wires
6802800U74-N September 2009
Make sure that all power is off to prevent accidental contact with high
energy and injury to personnel.
Do not use other types of DC Connectors than specified here.
• Blue/Black wires: see
• Red/Black wires: see Figure 4-20
–48 VDC Input Power and Backup Battery Charging Connections
Figure 4-19 for MTS 2 and
for MTS 2 and
Figure 4-21 for MTS 4.
Figure 4-22 for MTS 4.
4-23