Motorola DIMETRA MTS 2 Installation, Configuration And Basic Service Manual page 394

Base Radio Alarms
Table 13-7 Generic Base Radio Alarms (Continued)
Alarm ID
ALM_TX_TEMP_INTER-
NAL_FAULT
ALM_PA_TEMP_INTER-
NAL_WARN
ALM_PA_TEMP_INTER-
NAL_FAULT
ALM_TX_TEMP_INTERNAL_SE-
VERE
ALM_PA_TEMP_INTERNAL_SE-
VERE
ALM_TX_DC_PS
ALM_PA_IN_RUSH_FAIL
ALM_TX_3_3V_PS
ALM_PA_3_3V_SUPPLY_FAIL
ALM_TX_5V_PS
ALM_PA_5V_SUPPLY_FAIL
13-28
Recovery
Description
Action
Internal Power BRC is de-keyed
Amplifier by the software.
temperature is
too high.
The same as ALM_TX_TEMP_INTERNAL_WARN
The same as ALM_TX_TEMP_INTERNAL_FAULT
Internal Power BRC is de-keyed
Amplifier by the software.
temperature is
too high.
The same as ALM_TX_TEMP_INTERNAL_SEVERE
Power Amplifier BRC is de-keyed
DC supply by the software.
failure.
The same as ALM_TX_DC_PS
Power Amplifier BRC is de-keyed
3.3V DC supply by the software.
failure.
Reported when ALM_TX_3_3V_PS is set and ALM_TX_DC_PS is cleared
Power Amplifier BRC is de-keyed
5V DC supply by the software.
failure.
Reported when ALM_TX_5V_PS is set and ALM_TX_DC_PS is cleared
Chapter 13: MTS Troubleshooting
Clear Action
If the alarm
condition
disappears the
alarm is cleared
and BRC can be
re-keyed again.
If the alarm
condition
disappears the
alarm is cleared
and BRC can be
re-keyed again.
If the alarm The alarm may be
condition reported because
disappears the of some power
alarm is cleared supply problems
and BRC can be
(cables, connectors)
re-keyed again. or the BRC hardware
failure / configuration
problem.
If the alarm The alarm may be
condition reported because
disappears the of some power
alarm is cleared supply problems
and BRC can be (cables, connectors)
re-keyed again. or the BRC hardware
failure / configuration
problem.
If the alarm The alarm may be
condition reported because
disappears the of some power
alarm is cleared supply problems
and BRC can be (cables, connectors)
re-keyed again. or the BRC hardware
failure / configuration
problem.
6802800U74-N September 2009
Notes