Configuration - Motorola DIMETRA MTS 2 Installation, Configuration And Basic Service Manual

Configuration
Configuration
Basic configuration of base radios is needed when additional base radio(s) has been added to the MTS
4 cabinet. This is described in
In addition to this, the following parameters need to be configured in TESS application:
•
•
•
•
•
•
15-24
Process 6-3, "Base Radio Configuration," on page
Base radios in the second Module Cage should be configured with cabi-
net:position set as 1:3 and 1:4.
For configurations with Manual Tuned Cavity Combiner(s), the MTCC needs to
be tuned after adding additional Base Radio.
Factory password
Field password
Cabinet ID
Position ID
Carrier Number (TX/RX frequencies are auto-generated based on Carrier Number setting)
Default TX Power level
When these parameters have been configured in TESS Application and after the
modified configuration file has been uploaded to the Site Controller, the complete site
needs to be reset to implement the configuration change.
Chapter 15: Expansion Options
6-13.
6802800U74-N September 2009