MTS 2 and MTS 4 Installation, Configuration and Basic Service Manual
6802800U74-N September 2009
When MTCC is used instead of ATCC, connect the cables to corresponding inputs and outputs.
In the Prime Cabinet, detach the Post Filter cable in the prime cabinet from the T connector
on the Interconnect Harness in the prime. Connect the free end of the Phasing Harness
from the expansion cabinet to the T connector on the Interconnect Harness in the prime
cabinet and connect the Post Filter cable to the T connector in the Phasing Harness. This
ensures that all eight channels are connected to a single Post Filter.
RX cables from Filters in Prime Cabinet to RX Splitters in the Expansion Cabinet
are routed through holes on the back side of the top-lid.
RF Cabling
5-47