Motorola DIMETRA MTS 2 Installation, Configuration And Basic Service Manual page 308

MTS - Configuring Ethernet Site Link
The .ethconf -STATUS command displays two sets of settings for each parameter:
•
•
------------------------------------------------------------------------
NOTE: Configuration cannot be saved due to errors or warnings below
------------------------------------------------------------------------
WARNING: Primary VLAN tagging shall be ON if primary WAN gateway is not set
ERROR: Primary WAN interface VLAN ID shall be 1-4095
ERROR: Primary IP tunnel remote address must be set
------------------------------------------------------------------------
All errors must be corrected before configuration can be saved
Warnings listed above indicate that configuration contains
non-standard settings which migh result in incorrect operation of Base Station
To save configuration without correcting warnings, please use
'.ethconf save -force' command.
When the Next values are successfully validated and saved into configuration file they
shall take effect after reset of Base Station.
8-32
Current: contains settings that were read from configuration file during startup
and are currently used by Base Station
Next: contains settings that can take effect after reset of Base Station.
* displayed in front of a particular parameter indicates that its value has been
changed by the user via .ethconf command. Before Those settings can be used,
they need to be successfully validated and saved in TSC configuration file.
This process is triggered by executing .ethconf save command. If
configuration cannot be successfully saved, User shall be instructed how to handle
detected errors and warnings as illustrated in the example below:
Chapter 8: Site Controller
6802800U74-N September 2009