Mts - Site Controller Software Version Check; Verifying Test Application Version - Motorola DIMETRA MTS 2 Installation, Configuration And Basic Service Manual

MTS – Site Controller Software Version Check
MTS – Site Controller Software Version Check
The MTS Site Controller should be loaded with the software provided on the MTS CD.
Versions later than the Baseline versions can be used. Please refer to the MTS Service Pack
Bulletin for version information and further details.
The Site Controller applications can be downloaded through SWDL Manager, but the
Test Application must be upgraded locally on site.

Verifying Test Application Version

Test Application version is verified from Boot1 mode. While in Boot1 mode, enter Test App
mode by using the following command: SC> testapp.
The version should be displayed in the startup text as exemplified below.
Transferring control to image entrypoint at 0x8064.
Motorola Inc.
Platform Test Application Version=TSC_RLJ_TESTAPP-E06.40.06
At the factory prompt, use the following command: fv –oplatform.
The current Test App software version is displayed in the first line of the output, as in example below:
Test Application Version =TSC_RLJ_TESTAPP-E06.40.06
OS Version =OSE 4.5.2
Core Software Ver=TSC_RLJ_PLAT_27_SEP_06
Enter reset –oplatform to reset the Site Controller.
8-50
– Copyright 2006
If Test Application version number is not displayed in the startup text, follow the step below.
The reset –oplatform command is not supported for older Test Application versions. Instead
press and hold the Reset button for a few seconds until all LEDs on the Site Controller lights up.
Chapter 8: Site Controller
6802800U74-N September 2009