Motorola DIMETRA MTS 2 Installation, Configuration And Basic Service Manual page 458

How to Install
Procedure 15-5 How to Add Redundant Site Controller
1
2
3
4
5
6
7
8
9
15-28
Wear an ESD strap and connect its cable to a verified good ground. This strap must be worn
to prevent ESD damage to any components.
Remove the Site Controller Blind Plate.
Label the cables with labels included in the expansion kit.
Connect the Ethernet cables to the Base Radio(s) according to the scheme below:
Part no
3066544B02
3066544B15
3066544B16
3066544B01
At this stage only connect the cables to the Base Radios
Strap the cables.
Connect RF cable 3066543B10 to the GPS2 connector on the Junction Panel and let it hang.
Catch the cable in the empty space where the Site Controller is to be assembled and temporarily
fix it at the front.
Install the Site Controller. Use the handle to slide the unit into the chassis.
Connect the ribbon cables at the rear before sliding the unit into the chassis. Be
careful not to damage the cables when sliding the Site Controller into place.
Secure the Site Controller in the chassis with two M4X10 captive screws.
Connect the Ethernet cables previously attached to the Base Radio(s) to the Site Controller. Also
connect the newly added Site Controller to the junction panel according to the scheme below:
Part no
3066543B10
3066560B01
3066567B02
Connect RF cable 3066543B10 to GPS connector.
Cable type From
Ethernet cable SC2 / BR4
Ethernet cable SC2 / BR1
Ethernet cable SC2 / BR2
Ethernet cable SC2 / BR3
From
Cable type
RF Cable Junction Panel /
E1
Y splitter
Y splitter
Chapter 15: Expansion Options
To
BR4 / SC2
BR1 / SC2
BR2 / SC2
BR3 / SC2
To
Y splitter
SC1 / E1
SC2 / E1
6802800U74-N September 2009