Advertisement
Inspection Procedure
4.3
Connector Inspection Example
Step 2
Set the judgment conditions for the dimensions
A Gray Scale Edge checker can perform judgments based on the number of edges
detected, it cannot measure dimensions.
To do this, use the detected results in a numerical calculation as illustrated below.
Edge A
Edge B
Calculation example
You can set maximum and minimum values for the dimension obtained here, and
perform judgment.
Refer to 13.3 Numerical Calculation for details regarding numerical calculations.
Step 3
Perform an inspection
1.
Return to the main menu and press the A (Start) key to
perform an inspection on a new target object.
The dimension is calculated based on the detection results of
the Gray Scale Edge checker. If you establish judgment
conditions for the Numerical Calculation function and index
the judgment output, you can output the judgment result to
an external device.
It is also possible to output calculation data to external
devices. See Communication Settings in the Environment
menu.
4 − 14
−
X coordinate of part B
X coordinate of part A=Dimension from A to B
. . . .
GE01021
GE01011
OCR Type A230
Advertisement
