Advertisement
Inspection Results and Output
13.3
Numerical Calculation
13.3 Numerical Calculation
13.3.1
About Numerical Calculations
Programmes can be created to carry out numerical calculations on the results of
measurements by checkers. You can set up to a maximum of 32 formulas for each type.
The image cannot be changed once you enter the Numerical Calculation menu, so if
you wish to be able to see a particular image during numerical calculation setup, change
to the required image before entering the Numerical Calculation menu.
Numerical calculation Setting menu
8
(1)
(5)
(6)
(7)
(1) Register No.
The
register
programmes.These are displayed four at a time. Move the cursor lever left or right
to display the previous or following four registers.
(2)−1 Calculation result
Displays the result of the numerical calculation
(2)−2 Calculation result
Displays the result of the numerical calculation
However, if the result exceeds eight digits, "*****" is displayed.
(3) Judgment
Judges the result of numerical calculation to be OK if it is within the specified upper
and lower limits, and NG if it exceeds the limits. Displays the result of judgment.
If a checker existed at the point of setup but has since been deleted, or if there is
an item which could previously be selected but can no longer be used for
calculations, then the judgment result in error and "ER" is displayed.
13 − 6
(2)−2 (2)−1
(4)
setting
No.
(CA01
(3)
to
CA32)
for
OCR Type A230
numerical
calculation
Advertisement
