Table of Contents
Advertisement
• Ensuring that no additional components are integrated in to the APAS assistant
which impair or disable the existing safety functions.
• Passwords for the KUKA System Software user groups must only be communicated
to authorized personnel.
2.9 General safety instructions
• As the owner, please note the following: before the initial commissioning of the
product, carry out a risk assessment in accordance with the national regulations in
your country (in Germany: according to the Occupational Health and Safety Act).
• As the distributing company/manufacturer of the machine, observe the following:
Before the initial commissioning of the machine, conduct a risk assessment in
accordance with DIN EN ISO 12100.
• Observe the applicable accident prevention and environmental protection
regulations.
• Observe the safety rules and regulations of the country in which the product is
being used.
• Only use Rexroth products that are in proper working order.
• Observe all the notices on the product.
• Persons who assemble, operate, disassemble or maintain Rexroth products should
not be under the influence of alcohol, drugs or medication that may affect their
ability to respond.
• Use only original accessories and spare parts from Rexroth in order to prevent
hazards to people due to unsuitable spare parts.
• Observe the technical data and ambient conditions specified in the product
documentation.
2.10 Product-specific safety instructions
• Make sure that the EMERGENCY STOP button of the smartPAD is easily accessible
by the personnel at all times.
If the APAS assistant and the overall system share an EMERGENCY STOP circuit
and operating the overall system is possible even when the robot controller is
switched off, the smartPAD must either be covered or removed from the overall
system. This serves to prevent hazards resulting from a confusion of effective and
ineffective EMERGENCY STOP devices. Disconnected smartPADs must be removed
from the area around the overall system immediately
• Prior to working on the product:
– Secure a sufficiently large work area.
– Inform the operating personnel and assign a supervisor.
– Observe the notices on the residual risk.
• Make sure that the product is only operated and monitored by personnel instructed
on the safety technology in operating modes T1 and T2.
• Do not touch any moving parts in automatic mode and test run mode.
• Do not modify or remove the protective panels.
3 842 565 050/2019-11 APAS assistant K1100-10i V01.00.00 - V01.00.99, Bosch Rexroth AG
Safety instructions
15/68
Advertisement
Table of Contents
