Configuration Save & Restore; The "Show" Commands; Show Running-Config - Siemens SIMATIC NET Configuration Manual

Configuration
3.4 Configuration Save & Restore
3.4 Configuration Save & Restore
This section describes commands for displaying, saving and restoring configuration settings.
3.4.1

The "show" commands

This section describes commands with which you display various settings.
With the command
configuration mode.
To do this, you replace
Example
do show cli-console-timeout
3.4.1.1

show running-config

Description
This command shows configuration settings of the device.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show running-config
[{
syslog|dhcp|qos|stp|vlan<vlan-id(1-4094)>|
interface
ssh|ssl|acl|ip|snmp|radius|sntp|http|locked-port|
auto-logout|time|
ntp|auto-save|wlan
}][all]
82
do [command]
[command]
or
cli#
{
<interface-type><interface-id>|
vlan<vlan-id(1-4094)>
}|
you can execute the "show" commands in every
with the "show" command that you want to execute.
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05