No Ntp Server; Ntp Time Diff - Siemens SIMATIC NET Configuration Manual

System time
5.2 NTP client
5.2.3.2

no ntp server

Description
With this command, you delete the connection to a server on the NTP client.
Requirement
You are in the NTP configuration mode.
The command prompt is as follows:
cli(config-ntp)#
Syntax
Call the command without parameter assignment:
no ntp server
Result
The connection to a server is deleted on the NTP client.
Further notes
You configure the connection to a server with the
See also
Interface identifiers and addresses (Page 25)
5.2.3.3

ntp time diff

Description
With this command, you configure the time difference between the device and the NTP
server.
Requirement
You are in the NTP configuration mode.
The command prompt is as follows:
cli(config-ntp)#
122
command.
ntp server
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05