No Wlan Ipcf - Siemens SIMATIC NET Configuration Manual

Functions specific to SCALANCE
4.3 iPCF
cli (config-if-wlan-0-X)#
Syntax
Call the command without parameters:
wlan ipcf
Result
The iPCF mode is enabled.
Further notes
You disable the iPCF mode with the
You display the setting with the
4.3.2.2

no wlan ipcf

Note
The command is only available with the following device:
• SCALANCE W722-1 RJ-45 (MLFB 6GK5722-1FC00-0AA0 and 6GK5722-1FC00-0AB0
(US version))
Description
With this command, you disable the iPCF mode.
Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call the command without parameters:
no wlan ipcf
Result
The iPCF mode is disabled.
Further notes
You enable the iPCF mode with the
You display the setting with the
102
command.
no wlan ipcf
command.
show wlan ipcf
command.
wlan ipcf
command.
show wlan ipcf
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05